Dating Fossils – How Are Fossils Dated? - okinawa-net.info
Thus, when a particular fossil is identified in a sedimentary rock, we can tell whether the rock is 2) Radiometric age determination - analysing the very small quantities of radioactive elements Absolute age dating. – atomic spectroscopy. Relative age dating. HELPFUL TERMS. Paleontologists. Isotope. Radioactive decay. Determining the Age of. Rocks and Fossils. 1. New York State Standards. 1. Radiometric dating is used to estimate the age of rocks and other objects Relative Dating with Fossils: Index Fossils as Indicators of Time.
Scientists can use certain types of fossils referred to as index fossils to assist in relative dating via correlation. Index fossils are fossils that are known to only occur within a very specific age range. Typically commonly occurring fossils that had a widespread geographic distribution such as brachiopods, trilobites, and ammonites work best as index fossils. If the fossil you are trying to date occurs alongside one of these index fossils, then the fossil you are dating must fall into the age range of the index fossil.
Sometimes multiple index fossils can be used. In a hypothetical example, a rock formation contains fossils of a type of brachiopod known to occur between and million years. The same rock formation also contains a type of trilobite that was known to live to million years ago.
Since the rock formation contains both types of fossils the ago of the rock formation must be in the overlapping date range of to million years. Studying the layers of rock or strata can also be useful.
Layers of rock are deposited sequentially. If a layer of rock containing the fossil is higher up in the sequence that another layer, you know that layer must be younger in age. This can often be complicated by the fact that geological forces can cause faulting and tilting of rocks. Absolute Dating Absolute dating is used to determine a precise age of a rock or fossil through radiometric dating methods.
This uses radioactive minerals that occur in rocks and fossils almost like a geological clock. So, often layers of volcanic rocks above and below the layers containing fossils can be dated to provide a date range for the fossil containing rocks.
The atoms in some chemical elements have different forms, called isotopes. These isotopes break down at a constant rate over time through radioactive decay.
DETERMINING AGE OF ROCKS AND FOSSILS
Uranium—lead dating A concordia diagram as used in uranium—lead datingwith data from the Pfunze BeltZimbabwe. This scheme has been refined to the point that the error margin in dates of rocks can be as low as less than two million years in two-and-a-half billion years. Zircon has a very high closure temperature, is resistant to mechanical weathering and is very chemically inert.Darth Dawkins: Fossils and Radiometric Dating
Zircon also forms multiple crystal layers during metamorphic events, which each may record an isotopic age of the event. This can be seen in the concordia diagram, where the samples plot along an errorchron straight line which intersects the concordia curve at the age of the sample.
Samarium—neodymium dating method[ edit ] Main article: Samarium—neodymium dating This involves the alpha decay of Sm to Nd with a half-life of 1. Accuracy levels of within twenty million years in ages of two-and-a-half billion years are achievable. Potassium—argon dating This involves electron capture or positron decay of potassium to argon Potassium has a half-life of 1.
Rubidium—strontium dating method[ edit ] Main article: Rubidium—strontium dating This is based on the beta decay of rubidium to strontiumwith a half-life of 50 billion years. This scheme is used to date old igneous and metamorphic rocksand has also been used to date lunar samples. Closure temperatures are so high that they are not a concern. Rubidium-strontium dating is not as precise as the uranium-lead method, with errors of 30 to 50 million years for a 3-billion-year-old sample.
Uranium—thorium dating method[ edit ] Main article: Uranium—thorium dating A relatively short-range dating technique is based on the decay of uranium into thorium, a substance with a half-life of about 80, years.
It is accompanied by a sister process, in which uranium decays into protactinium, which has a half-life of 32, years. While uranium is water-soluble, thorium and protactinium are not, and so they are selectively precipitated into ocean-floor sedimentsfrom which their ratios are measured.
The scheme has a range of several hundred thousand years. A related method is ionium—thorium datingwhich measures the ratio of ionium thorium to thorium in ocean sediment.
Radiocarbon dating method[ edit ] Main article: Carbon is a radioactive isotope of carbon, with a half-life of 5, years,   which is very short compared with the above isotopes and decays into nitrogen. Carbon, though, is continuously created through collisions of neutrons generated by cosmic rays with nitrogen in the upper atmosphere and thus remains at a near-constant level on Earth.
The carbon ends up as a trace component in atmospheric carbon dioxide CO2.
A carbon-based life form acquires carbon during its lifetime. Plants acquire it through photosynthesisand animals acquire it from consumption of plants and other animals. When an organism dies, it ceases to take in new carbon, and the existing isotope decays with a characteristic half-life years.
The proportion of carbon left when the remains of the organism are examined provides an indication of the time elapsed since its death.
This makes carbon an ideal dating method to date the age of bones or the remains of an organism. The carbon dating limit lies around 58, to 62, years. However, local eruptions of volcanoes or other events that give off large amounts of carbon dioxide can reduce local concentrations of carbon and give inaccurate dates.
The releases of carbon dioxide into the biosphere as a consequence of industrialization have also depressed the proportion of carbon by a few percent; conversely, the amount of carbon was increased by above-ground nuclear bomb tests that were conducted into the early s. Also, an increase in the solar wind or the Earth's magnetic field above the current value would depress the amount of carbon created in the atmosphere.
Fission track dating method[ edit ] Main article: This involves inspection of a polished slice of a material to determine the density of "track" markings left in it by the spontaneous fission of uranium impurities. The uranium content of the sample has to be known, but that can be determined by placing a plastic film over the polished slice of the material, and bombarding it with slow neutrons.
This causes induced fission of U, as opposed to the spontaneous fission of U. The fission tracks produced by this process are recorded in the plastic film. The uranium content of the material can then be calculated from the number of tracks and the neutron flux. This scheme has application over a wide range of geologic dates. For dates up to a few million years micastektites glass fragments from volcanic eruptionsand meteorites are best used.
Older materials can be dated using zirconapatitetitaniteepidote and garnet which have a variable amount of uranium content. The technique has potential applications for detailing the thermal history of a deposit. The residence time of 36Cl in the atmosphere is about 1 week. Thus, as an event marker of s water in soil and ground water, 36Cl is also useful for dating waters less than 50 years before the present.
Luminescence dating methods[ edit ] Main article: Luminescence dating Luminescence dating methods are not radiometric dating methods in that they do not rely on abundances of isotopes to calculate age.
Instead, they are a consequence of background radiation on certain minerals. Over time, ionizing radiation is absorbed by mineral grains in sediments and archaeological materials such as quartz and potassium feldspar. The radiation causes charge to remain within the grains in structurally unstable "electron traps". Exposure to sunlight or heat releases these charges, effectively "bleaching" the sample and resetting the clock to zero.
The trapped charge accumulates over time at a rate determined by the amount of background radiation at the location where the sample was buried. Stimulating these mineral grains using either light optically stimulated luminescence or infrared stimulated luminescence dating or heat thermoluminescence dating causes a luminescence signal to be emitted as the stored unstable electron energy is released, the intensity of which varies depending on the amount of radiation absorbed during burial and specific properties of the mineral.